Is this the Chinese version of the new Land Rover Defender, based on the DC100 concept? No, just a copy from BAIC
-
To the color of the car found metallic effect, it must be painted with two coats. The first layer - the base, the second layer - paint. It is very important to select quality materials and of course to use them properly. Just need a more thorough preparation of the body. For the first layer of paint need to "Nitro", she will give the color and the desired effect, for the second layer of paint will be needed, it will give a shiny car, as well as protect the body from the external environment. So, the first stage of painting is the preparation of the body. In the first of its surface must be degreased. This will require antisilikonovaya liquid, it can be purchased in any auto shops, and clean towels. On one napkin to cause the liquid and the second will need to wipe the surface dry. This stage requires particular attention. Better quality than its produce, the better will be painting in general. The second stage - it's blowing a car. Blowing can be performed before and after de-oiling it. But to save time it can be done only after degreasing. Blowing should be carried out to remove all the small mote and dust, otherwise they shall cleave to the body during the painting and spoil the view. After rinsing the body additionally be treated dust cloth, with her removed to the smallest speck of dust. Next, the third stage - the application of paint. It should be done only with paint. So when painting is not a band or spots of different shades, it must be applied in two layers. The first layer, we can not hesitate to put on tap, with the help of this, we paint the spots of soil and give the body a uniform color. If you do not get the desired results, then painted again, but only after the evaporation of the solvent. The last deposited layer should be opaque, which means that evaporation occurred hardener. Only after that can be taken as the most important base layer, which should not retain the stripes and spots. To do this, add the solvent in the paint and increase the flow of air in the gun. Apply paint to spraying, you will need to make sure that the layer was deposited on the surface of the body evenly. And finally, the final stage - covering car polish. This stage is the easiest. Here the most important thing to prevent stains. Varnish should be applied uniformly in two or three layers. Between them to produce dried and tested for tack. To do this lightly presses his finger to the lacquered surface, and then detaches it, but will hear the sound of "plunk" and the particles of varnish should not stick to your finger. After just the second layer is uniformly covered with lacquer. Thoroughly dried. To speed up the drying can increase the temperature of the room where the painting is made. When necessary to apply a third layer. Painting a car is finished, but to bring everything to the mind, it must be polished. To do this, you will need an ordinary wax which is based, is wax or polish. Rub the polish to a soft cloth, in any case, it is impossible to do with the open sun, as sunlight heats the body, and polish on it starts to dry out very quickly.
